Skip to product information

Browning "RIMFIRE GROOVE" Sight

$85.00
$85.00
Shipping calculated at checkout.
Material

Description

The SKINNER RIMFIRE sight is designed to be as simple and durable as possible with minimal bulk.  My goal was to produce a sight that does NOT have protrusions, fragile clamps or require gunsmithing to install.

Consequently, our securing system requires close tolerances and is MAKE AND MODEL Specific.  

Our RIMFIRE SIGHT is adjustable for windage and elevation, the same as our other SKINNER SIGHTS and comes with the wrenches needed to install and adjust.

MOUNTING A RECEIVER SIGHT ON ANY RIFLE WILL OFTEN REQUIRE A FRONT SIGHT CHANGE.  PLEASE...  READ THE INFORMATION ON OUR FAQ PAGE FOR ANSWERS ABOUT FRONT SIGHT SELECTION.

Mounting Instructions: 
Remove your existing barrel mounted rear sight (using a brass punch) and replace it with a dovetail blank.

Ships with a .096" aperture installed. Accepts all 5 Skinner Aperture sizes.

Wrenches for mounting and adjustment included.

Loosen the rear "pinch" screw on the Skinner RIMFIRE sight and slide it carefully onto the top receiver "GROOVES" from the rear of the receiver.  Set in the desired position and tighten the rear "pinch" screw enough to keep the sight from sliding.

(Due to variables in receiver groove sizes, slight fitting may be required.  No pounding to install.  If fitting is needed, fit until the sight will slip on with firm thumb pressure.  If there are questions, please give us a call @ 406-745-4570) 

Tab title

The SKINNER RIMFIRE sight is designed to be as simple and durable as possible with minimal bulk.  My goal was to produce a sight that does NOT have protrusions, fragile clamps or require gunsmithing to install.

Consequently, our securing system requires close tolerances and is MAKE AND MODEL Specific.  

Our RIMFIRE SIGHT is adjustable for windage and elevation, the same as our other SKINNER SIGHTS and comes with the wrenches needed to install and adjust.

MOUNTING A RECEIVER SIGHT ON ANY RIFLE WILL OFTEN REQUIRE A FRONT SIGHT CHANGE.  PLEASE...  READ THE INFORMATION ON OUR FAQ PAGE FOR ANSWERS ABOUT FRONT SIGHT SELECTION.

Mounting Instructions: 
Remove your existing barrel mounted rear sight (using a brass punch) and replace it with a dovetail blank.

Ships with a .096" aperture installed. Accepts all 5 Skinner Aperture sizes.

Wrenches for mounting and adjustment included.

Loosen the rear "pinch" screw on the Skinner RIMFIRE sight and slide it carefully onto the top receiver "GROOVES" from the rear of the receiver.  Set in the desired position and tighten the rear "pinch" screw enough to keep the sight from sliding.

(Due to variables in receiver groove sizes, slight fitting may be required.  No pounding to install.  If fitting is needed, fit until the sight will slip on with firm thumb pressure.  If there are questions, please give us a call @ 406-745-4570)